![]() ![]() Fixed an issue with rest shadow air cut reduction in pocket clearing that was not working correctly.Fixed an issue where a toopath did not reach all accessible areas when using holder protection (pull-away) in rest machining.Fixed an issue in which adaptive toolpaths that were trimmed by holder collision protection were not respecting the minimum cutting radius.Fixed several additional cases where adaptive clearing failed to calculate a toolpath.Fixed an issue for adaptive toolpaths where a ramp into pockets without a suitable predrill position was used in some circumstances.Fixed an issue for adaptive where a ramp diameter close to the maximum possible diameter for a given pocket could cause the application to hang. ![]() Fixed an issue in which the adaptive clearing toolpath would not generate in specific circumstances.Fixed an issue in which adaptive clearing unexpectedly reversed the cut direction mid-move, which could lead to a tool breakage.The following changes were made in an earlier update (2022.2): Fixed an issue in which HSM Edit's Transforms Group was disabled.Fixed an issue in which machining angles could be calculated incorrectly in some cases.Improved the section bounding box as calculated by the getRange functions so that it now includes milling and boring cycle movements.Improved the property handling functions (getProperty, setProperty) in the post-processor.Improved linking in the pocket strategy with enabled rest machining to avoid air cutting ramps.Fixed a stock collision that could occur in 3D adaptive clearing when 'Order by Area' was selected.Fixed several cases where a ramp cutting into the part was generated.Fixed a toolpath calculation failure that could occur in a slot strategy which produced an "Invalid Contours" error.Fixed crashes that could occur in some cases when using the jet, spiral, or trace strategies. ![]()
0 Comments
Leave a Reply. |